Notice: My Pluto-P board was fried because of a short in the Power connection so I am not using it any more. It was quite a pain to get it to work and I am using this post to help other users who happen to have bought a Pluto-P board so that they have easier experiences. I wanted to use a Pluto-P Board for LinuxCNC since I had already bought this board I wanted to try to get it to work....
Mein Hugo Setup verwendet hugo und das nix theme. Hugo wurde dabei von mir als nicht-priviligierter Benutzer installiert. Dazu muss man sich mit ‘adduser hugo’ den Benutzer hugo anlegen. Im Homeverzeichnis neu erstellten Benutzers entpackt man nun das .deb file welches man auf der Website von Hugo herunterladen kann. Danach muss man noch den bin Ordner zur Pfadvariable hinzufügen und schon kann man hugo verwenden....
The reading of the Nunchuck is similar to read of the motionplus. The biggest Problems are the timining errors. Since i used a 16MHz Oscillator my microcontroller an 400khz as my I2C speed, the communication was often to fast when reading the data. When this happens the nunchuck hangs and does nothing more. Motion Plus I2C Adress: 0xa4 I2C Enable Register 0xf0 (Value 0x55) I2C Extension ID: 0xFA to 0xFF (0000 A420 0000)...
Hallo Welt! ding...